Most folks figure an electric truck has to be a silent, shiny, one-pedal appliance. Then along comes a farm-fresh Chevy 3100 with its original doors, faded paint and a clutch pedal, and everything gets turned upside down. The shop behind it, EVTUNERS and Classic EV Conversions, took it out for a test drive with a visitor who had never shifted an electric vehicle before.

A red vintage pickup truck parked behind a wooden fence

The big surprise is right in the gearbox. It is a 5 speed manual, yet it runs on batteries, and because of that, the driver can start in any gear. Put it in fifth, keep a foot on the brake, and the old truck begins creeping forward.

“I Want Heat, I Want AC, I Want A New Radio” Is What The Farmer Asked For

The builder explains that the customer’s goal was simple. He wanted an old farm truck that looks cool, one he could still shift like the farm truck it is, drive with his dog and haul stuff in. But he also wanted heat, air conditioning and a new radio, with everything working as it should in a modern vehicle.

It was the kind of project where the shop sat down and asked what the owner would do if the truck were his. The inside is pretty much all original, including the gauges, which run through an opening ceremony when the key is turned on. A knob on the dash also lets the driver pick regen settings, which is handy for friends who have never felt regenerative braking.

A 63 KW Tesla Battery Pack And A Hyper 9 Motor Ride Under The Old Sheet Metal

Under the truck sits a Hyper 9 motor and a 63 kW Tesla battery pack. The system is split front to rear and bolted into the chassis, so everything can come out by unbolting it, with the front box lifting up and the rear box dropping down. The idea was to keep the truck as original as possible, upgrade it without hacking it up, and leave the door open to swapping in a different motor later.

The pack is ten Tesla modules of 6.3 kWh each, wired in what the builder calls a 5S2P arrangement. Pairs of modules are wired together, and those pairs are then connected in series. The builder says that gives more range and less voltage sag.

Here is a twist for anybody dreaming of a quick fill-up. The truck has a Tesla charge port, but it charges only at level one and level two, since it is not a 400 volt system and does not have fast charging.

“You Do Not Need The Clutch To Start Or Stop” And Other Surprises

Then the visitor got behind the wheel, which was also the first manual EV the visitor had ever driven. The builder explained the trick. You only need the clutch when shifting between gears while moving. When you lift off the gas, the motor starts regenerating and slows down, so you give it a little gas while the clutch is in to let the motor free spin, and it matches up as you let the clutch out.

If you skip the gas and just release the clutch, the builder says it will tug you down because the motor is trying to stop you. The first attempt came with a couple of clunks, and the builder graded it a seven out of 10. A second attempt earned a seven and a half, with advice to barely rest a foot on the pedal rather than blip it.

Other upgrades are easy to miss. The shop built a brand new wiring harness wrapped in a special tape because the owner lives on a farm, which makes the whole thing mouse proof. The cab is also fully sound deadened, which cuts exterior noise but still lets the motor be heard.

“EVs Don’t Make Noise? Not True,” Says The Builder

That is the line that sums up the sound. The builder said the truck sounds mean and raw and means business, with a bit of a space age tone that still fits the era. The driver agreed it feels fitting for the age of the truck, with an almost analog quality.

On the road, cruising at about 45 miles an hour felt like the sweet spot, and the truck simply cruises. Starting in third is a little slower, though still drivable, and it did not lug in a bad way. The regen setting started on low and can be set higher, and the regen changes with each gear because of the gear ratios.

The visitor called it probably the oldest truck ever driven, and an electric one at that, which felt weird. The suspension felt a little harsh, though a bit softer than a Fiero he compared it to, and the visitor figured the truck turns heads everywhere. Building a patina truck is one of the hardest things to do, the builder said, because patina cannot be mimicked, and if anything goes wrong, you start over.

For anybody who loves old trucks but wonders about electric power, this build makes a case that the two are not enemies. Keep the old look, keep the gearshift, add the heat and air, and you may end up with something that feels familiar and brand new at once. The shop also says its team built a BMW into the back of an S10 before, so this one was a chance to keep things original.

More Stories You May Like

Leave a Reply

Your email address will not be published. Required fields are marked *