A 1965 Pontiac GTO is sitting in a New England driveway with a mystery V8 under the hood, and for a while that engine would not budge. Not a quarter turn, not a wiggle. Locked up solid.

The man behind the wrenches is @5150mxVW, a Volkswagen guy by habit who says this is his first time digging into a big American engine like this. He hauled the GTO home two years ago, and now it is finally time to find out whether the heart of the car can be saved.
The first attempt did not go well. After the plugs came out and the car had soaked for a week, he gave it a try and said flatly, “She did not want to turn.”
A Week Of Soaking Wasn’t Enough, So He Asked The Comments For Help
The earlier video showed him discovering the engine was seized, and the comment section filled up with advice. He says he read as many as he could and promised to work through the suggestions before pulling the motor out of the car.
Rust turned out to be limited to cylinders one and two. Those were the only two hanging up, and the scope showed the other side of the engine looked good. That meant the problem was a small patch of corrosion, not a total disaster.
He also took in a few opinions that were not so kind. A Mopar buddy of his, he says, called Pontiac people a bunch of weirdos, told him these 400 engines are junk, and guessed the motor probably spun a crank bearing. The owner shrugged it off with, “Let’s hope he’s wrong.”
He Skipped The Vinegar And Filled The Cylinders With Old ATF
One viewer told him to swap in an LS engine. His answer was blunt: there is “no way” that car gets an LS under his watch. The GTO stays Pontiac.
Part of him wanted to pour vinegar in to dissolve the rust, but he went with old automatic transmission fluid instead. He filled cylinders one and two, tilted the engine and rotated it to get coverage, and used a product called Marvel on an earlier job that he says always works well.
He also took the suggestion to check the oil for water, since someone pointed out the level sat above the mark. The oil had some grit in it, so he planned to crack the drain and see whether any water came out.
“She’s Budging”: A Small Pull On The Flywheel Finally Moved Something
Next came the flywheel. Plenty of commenters said to get on it with a tool and put a little pressure on, but he was careful. He did not want to snap the studs on the header, so he leaned on it gently.
Then something gave. “She’s budging. Can you see that?” he says. Another viewer had told him to go backward, so he tried counterclockwise, and it moved away from the rust. “Oh yeah, she is moving.”
He pumped another quart of ATF into one and two and left it to soak overnight. The goal was to let the fluid dissolve whatever rust remained before trying for a full revolution.
Old Timer Tricks Came Out, From Belts To A PB Blaster Test
The next morning he looked at the cylinders with a scope and reported no visible rust on the walls he could see. He decided to go for it.
Other tips from the crowd came into play too. He took the belts off, and he finally pulled the fan blade, which meant removing the radiator. He joked about the viewers who yelled for the fan blade and the one who yelled that he would need to take the radiator out to do it.
A hose clamp gave him a chance to test an old-timer favorite. “Let’s see PB Blaster do that on a hose clamp,” he says, spraying rusty hardware and admitting the dose was “a little bit overkill.” Since the radiator is not going back in, he says he could get “a little medieval on it.”
He says he is starting to like working on American cars. He even found the room under the hood a surprise, and the belt coming on and off easily was a first for him.
The Valvetrain Moved, But A Score Mark Showed Up On Cylinder One
With the engine turning by hand, he watched the valvetrain and confirmed everything was moving. Fluid sprayed out, a lot of ATF, which he says proves how full he had filled one cylinder. He marked a notch on the balancer to track a full circle, then rotated clockwise and the engine went all the way around.
That was the good news. The less welcome news came when the camera looked into cylinder number one and found a score mark. “Oh shoot, that’s what I was afraid of,” he says, adding that had he soaked it when he brought the car home two years ago, the mark could probably have been avoided.
He gave a nod to his inspection camera, a dual lens scope with a split screen. He admits he skipped the instructions at first, noticed the side camera late, and says it is a really cool tool to own.
Jump Pack, Weak Battery, Then “She Freaking Turns”
With the engine free by hand, he wanted to know if it would turn over under power. He says he has nine batteries sitting around because they are up the street, and the one he grabbed was half dead. He used a jump pack and says it would give 24 volts, so “she’ll be fine.”
The dash lights came on. He told the camera to get ready, turned the key, and the engine rolled. “Oh, she freaking turns. Watch it. Oh, she freaking turns. Oh, I am so pumped right now.”
He says he never expected it to turn over. One more oddity: there was a snake in the intake, and garter snakes were all over the trailer when he loaded the car.
What To Know Before You Try This On A Seized Engine
His method follows a pattern that old mechanics have used for decades: patience first, force last. A week of soaking in penetrating fluid beats a cheater bar on the crank every time, and by his own account, cylinder walls that sit wet from the beginning can avoid scoring.
Pull the spark plugs and look inside with a scope before you do anything else. Find out which cylinders are holding the engine hostage, because in this GTO it was only two out of eight.
Turn the engine gently by hand with a breaker bar on the crank bolt or the flywheel, and be ready to try both directions. Watch for fragile parts such as header studs, and remove belts and the fan so you are only fighting the engine itself.
Check the oil for water and grit before cranking it under power. Use a healthy battery or a booster pack so the starter does not struggle, and understand that spinning freely does not mean the bottom end is healthy. His own next question to viewers is what comes after this: the car still needs floor pans and trunk rust repair before winter.
For now, that Pontiac 400 is off the “might need a motor” list and onto the “it runs a lap” list, and a driveway in New England is very happy about it.
More Stories You May Like
- Ford Recalls 102,159 Super Duty And F-150 Trucks Over Gauges That Can Stick Or Go Haywire, But Ford Says Only About 1% Actually Have The Defect
- GM Recalls 67,380 Electric Cadillacs And Chevy Blazer EVs Because A Brake Software Glitch Can Reduce Braking After A Light Tap In A Sharp Turn
- Ford Recalls 30,123 F Series Trucks Because A Tailgate Cable Can Snap And Drop The Tailgate, Traced To A Broken Crimping Die That Ford Says Affects About 2%
